For many remodeling jobs, incorporating passive solar design is simply not an option. On a simple bathroom or kitchen remodel, for instance, it's probably not a good fit. But on major additions, whole-house remodels and numerous other jobs where window location can be altered and insulation concerns addressed, there are energy-efficiency gains to be had.
The techniques involved in designing to take advantage of the sun's rays are the same in every climate. Regardless of location, the goals are to maximize solar heat gain in winter and minimize it in the summer. Two key elements for achieving these goals are properly selecting and locating windows and ensuring the home is well-sealed and insulated. But there are many others that can be used depending on the job scope. The U.S. Department of Energy recommends incorporating the following elements:Insulation
Passive solar design's effectiveness will be significantly reduced if a home is not insulated and sealed effectively. By tightening the building envelope, using the International Code Council's recommended insulation levels (www.intlcode.org ), properly installing the insulation and repairing or replacing leaky ducts, you can effectively reduce heat loss and gain to prepare for further passive solar techniques.Windows
The science behind using windows is simple: when the sun shines through the glass, heat is trapped, which helps keep the house warm. The part that's not so simple is choosing the right windows and locating them for maximum heat gain or loss, depending on your market's climate.
In cold climates, maximize heat gain by locating many windows on the south-facing walls (7 percent of the building floor area is recommended) while reducing the number of windows on the north, east and west. Choose windows with a high solar heat gain coefficient (.60 or higher is recommended) and low U-factor (.35 or less is recommended) to reduce heat transfer. You'll also have more visible light transmitted.
In warm climates, locate fewer windows on the south facing walls and more on the other sides. To reduce heat gain on the south-facing windows, install solar window screens, shutters, oversized overhangs or landscaping to reduce the effects of the full sun. The Department of Energy recommends you specify windows that have a U-factor below .4 and a solar heat gain coefficient below .55 in warm climates.Shading
Because the sun rises higher overhead in summer than in winter, properly sizing window overhangs or awnings can help heat a home in winter and cool it in summer. To properly size an overhang for optimum effectiveness, follow these five steps:
Increasing the natural light in a home can decrease the homeowner's electric bill. Generally, glazing should account for at least 5 percent of a room's floor area for effective daylighting. Install windows with low-E coatings and a high visible light transmittance to minimize glare while allowing for proper heat gain and loss characteristics. Skylights can also provide additional natural light.Natural Cooling
Natural cooling techniques help capture cooling breezes and reduce the need for mechanical cooling, thereby lowering energy bills.
The stack effect, or chimney effect, is one technique that can be used for this purpose in two-story homes. Create a design with second-floor exit windows, ridge vents, whole-house fans or other openings that will draw warm air out of the top of the home and first-floor windows or vents where cool air can enter.
If you have ideas or comments, e-mail the author at firstname.lastname@example.org .